Silentknight 5499 9A Distributed Power Module Instrukcja Użytkownika Pobierz pdf (Strona 31)

Troubleshooting

151253 27

Section 6

Troubleshooting

Light-emitting diodes (LEDs) indicate fault conditions. This section describes the LED

states.

6.1 LEDs

The eight LEDs indicate a fault in one of the circuits (either NACs 1 through 4,

auxiliary power, earth fault, low AC, or battery). A fault in the LED's corresponding

circuit will light the LED (labeled on the board). Their functions are as follows:

See Figure 4-2 for locations of LEDs.

LED Color Description

OUT1 Yellow When ON, output circuit 1 is in trouble or in an overcurrent state.

OUT2 Yellow When ON, output circuit 2 is in trouble or in an overcurrent state.

OUT3 Yellow When ON, output circuit 3 is in trouble or in an overcurrent state.

OUT4 Yellow When ON, output circuit 4 is in trouble or in an overcurrent state.

AUX Yellow When ON, the auxiliary power output is in an overcurrent state.

FLT Yellow When ON, an earth ground fault on the unit exists.

BATT Yellow When ON, a low battery condition exists.

AC Green When OFF, there is no AC power to the unit. Under normal conditions, this LED

is ON to indicate the presence of AC power.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 55 56

Brak uwag

Silentknight 5499 9A Distributed Power Module Instrukcja Użytkownika Strona 31